I picked up this foot pedal switch at Harbor Freight last weekend on a whim. It was only nine bucks. I meant to use it with my dust collection system on the table saw, because I have to walk over and switch-off the rear mounted switch to kill it.
Of course I bought the wrong one, not paying attention. I bought the Momentary Power Foot Switch (#96619) rather than the Power Maintained Foot Switch (#96618) that I would have preferred. The difference is that the "momentary" pedal only switches on while your foot is on it, not good for table-saw work, while the "maintained" pedal clicks on and stays on until step on it again.
Of course I bought the wrong one, not paying attention. I bought the Momentary Power Foot Switch (#96619) rather than the Power Maintained Foot Switch (#96618) that I would have preferred. The difference is that the "momentary" pedal only switches on while your foot is on it, not good for table-saw work, while the "maintained" pedal clicks on and stays on until step on it again.
This sucks! |
I ended up installing my little Craftsman "Clean and Carry" 1.5 HP / 2 gallon vac to my miter saw. I plugged it into the load side of the switch, plugged the switch in, turned on the vac. It worked perfectly when I stepped on the pedal. The miter saw is a walk up and cut type operation. Just step on the switch while you cut. It was pretty good. The dust collection pick-up on the saw on the other hand wasn't the best. But it still was better than nothing.
Watch that first step, It's a doo-oozy!
-Ned Ryerson, Insurance Salesman
I've seen how expensive these types of switches are elsewhere. Shopsmith charges $38.65, plus freight for theirs, of course it's a lot nicer unit. But for this price, the Harbor Freight unit seems pretty decent. I'll grab the maintained switch next time. Let's see how long they last.